Does any shops stock jd2 stuff?

[singlehanded]

Want to convert my bender to hydraulic,but jd2 was closed when I called them. I am sure it will also take longer than I want to get the parts so I will just build it myself if nobody local (oc) has the conversion kit model3.

[mattb]

You might want to do a search. I think this has been covered.

[singlehanded]

Shorrs got some but the ram seems to be 4 shorter and they want like 600 bucks ouch. Well from a pm I guess nobody really has them in stock, so Ill just get a ram and make my own.

[Fourstroker]

Try Baja Racing Products in Fallbrook. That's where I got my bender

[mattb]

Here you go. On the upper tool bar, click on search, then enter JD2 hydraulic. You'll find a thread all about this subject. Scroll down to the title "JD2 Hydraulic."

[outtacontrazy]

i am abou5t to do this conversion here at the shop.....i have two buddies that have doen it and it works great. they said all said and done they spent about 650 wiht out the bender.....and notice how many degrees you can wqithout respinning the dye..

http://www.mindspring.com/~jayk5/bender/

[johnnyweb]

try mtechsupply.com thats were i bought mine and the prices were as good as any others found. also no taxes they are in arizona.

[mfs]

easy to do,i got a jd2 setup i build a table and a 2"bore 24" travel ram w/ a 3000psi pump,does a 90 degree bend in one shot. have to beef up my bender (made a whole new one )and i add 2 ears on to it so i could use the smaller dies (without drive holes)w the ram. if u want come by and i will let u check it out.

[mfs]

i have one of this for sale too.(bender only not the table)

[mfs]

the 3" bore ram makes it a lot slower has more power.just so u know,2" ram is good to bend 2" .120cr.table is nice so u can have a place to put the tubing when u lay out your bends,and as a welding bench.all my die hang under the table.also hight is important, u dont want to be bent over. notice how mine hang off and the way it swings that important too because you will get into probems where the tube hits the bender. mine works great. good luck.

[rubberboy]

Does anyone have one of those mtech benders. Are they pretty comprable to a jd2.

[mfs]

mine take 17 sec. for full extension.heres a nother pic

[14802]

m-tech is 100% the same, dies and everything..

[mfs]

selling this part only, brand new