PDA

View Full Version : Dual purpose potter car


under2
October 13th, 2007, 12:03
How would i know what size shocks to buy? Its a dual purpose car its going to probably weight 2600 lbs i want to go with 3 bypass kings and coil overs. What do i measure? How do i order?
motochris
October 13th, 2007, 15:59
Have you asked the manufacturer what it is setup for? If it's already got shock mounts, they set it up with SOMETHING in mind. I'de start there.
DSRacing
October 13th, 2007, 16:38
Have you asked the manufacturer what it is setup for? If it's already got shock mounts, they set it up with SOMETHING in mind. I'de start there.

Under his circumstances, I don't think talking to the builder is an option.

http://www.race-dezert.com/forum/showthread.php?p=342975#post342975

Without seeing the car or knowing it's state of completion, I would put the car on jackstands, grab a tape measure and cycle the suspension. Take measurements between the upper and lower shock mounts with the suspension at full compression and full droop. This should give you a basic idea on the stroke length of the shock you'll need. Then give King shocks a call.
151fab
October 14th, 2007, 08:41
Do you mean 3" bypass and coil-over; if so thats overkill. They weigh a ton and are much more expensive. If you mean 3 tube bypass and coil overs, I'd call King, let them know your set-up, and have them assist you in choosing. They'll sell you a set and leave them empty so that you can cycle them and clock the bypass/piggyback. Then when your ready take them back to them and they will assemble them. At that point I'd take the car to get weighed and you can then get a better idea of what spring weights you need. If the springs don't work out they will exchange them as much as you like until you are satisfied as long as you don't damage them.
hobie164
October 14th, 2007, 21:19
I have the shock sizes for potter cars. When I get home I will post you what you need to get. Just ordered mine. 2 week backorder, not bad from king
BrenthelIndustries
October 16th, 2007, 22:09
Worked on lots of Potter cars, be happy to help. Give us a call
Brenthel Industries 714-957-1228
Jonathan 949-232-6235
hobie164
October 17th, 2007, 17:38
Here is what you need.
Front Coil Carrier - 2.5x10
Front Bypass - 2.5x12
Rear Coil Carrier - 2.5x14
Rear Bypass - 2.5/3.0x16