Sandy Cone hubs on old school F100

[crash4519]

I have a 75 F100 and i am using 1 ton forged beams on it from a 73 F350.... The problem I am having is the bearings that i picked up to go into the hubs, the outer bearing (smaller one) fits absolutely perfect in the race in the hub... but the inner bearing (the larger one) doesn't fit that great.... is this how it is supposed to fit? or not?
Inner Bearing # Timken LM501349 and the race that i have for that bearing is #timken LM102910. The bearing fits fine on the spindle itself, (spindle is also off the same F350 as the beams came from). The hubs are the Sandy Cone "Cast 1 ton auto fab hubs". is a little slop on the inner bearing acceptable, or should it fit percise as my outer (smaller) bearing fits?

Please help
-Crash

[SpeedBump]

Where did you get the LM501349/LM102910 bearing/race combination? This does not look like a proper match to me.

[crash4519]

I had the 501349 bearings left over from the F350 spindles/hubs i had picked up from the junk yard... the race is what was currently the sandy cone hubs i had bought.... what ended up was me taking everything to my parts source and showing him everything and we concluded that the races were for E-350 spindles/hubs and not F-350... i guess thats what happens when i assume part numbers... haha. But i got it all sorted out, and new races.

[crash4519]

I attached a picture of the truck

[Dezertpilot]

Nice truck man!!!!

[boltonracing]

Give Sandy a call, be sure to leave a message!!! He is very busy but he will definetely call you back. You could also try calling Shannon Cone(Sandy's son) he will be able to help you out. They can be reached up untill about 9pm maybe a little later on the weekends especially Shannon.

Sandy 805-239-2663
Shannon 805-610-2438

[lowdownndirty]

Email autofab, Really John is a pretty helpfull guy.