Dimensioned drawing of King Coilover bearing assembly?

[ironbenderii]

I'm working on designing a set of LCA's and I need a measured drawing of a lower bearing assembly (shaft side) for some 2.5" King pre-runner shocks. I called King but they were less than helpful :(. Anybody have one, I've looked all over.

Jack Covert

[CRAIG_HALL]

I posted some on the trails less traveled site. king 2.5 prerunner's

[ironbenderii]

Great! Trails less traveled site? Got a URL?

Jack

[ironbenderii]

http://www.trailslesstraveled.com/resources/cadlibrary is this it? this is great - can't believe I didn't know about this place!

[rharriman]

I feel your pain and when I get mine done I will be sure to post them and if I can't find any reason not to I might just post a complete set of dimensional prints for each part of the shocks.:D

Not sure whats up but i will repost the above link, it doesn't work ( It was missing the final forward slash)

http://www.trailslesstraveled.com/resources/cadlibrary/

[movindirt]

Hows the truck coming Jack? Any pics? Heck now that gas in affordable I might have to make a run down your way...

[ironbenderii]

It's coming along a bit slowly, I took a few months off to do some house work. Last weekend was my first time back at it - it felt good to be there!!!