Quick LS1 engine question.

[dan200]

We think we have a main seal leak. Trans is separated. Is all there is to taking out the main seal just popping a flathead in the 3 little places at two, six and ten oclock on the case there is to removing the main seal? Anything we should know before taking the seal out?

Thanks

[Jerry Zaiden]

We think we have a main seal leak. Trans is separated. Is all there is to taking out the main seal just popping a flathead in the 3 little places at two, six and ten oclock on the case there is to removing the main seal? Anything we should know before taking the seal out?

Thanks

Yo Dan... look up at the very top of this website. Click on the Turn Key logo and give them a call! :D

[Ol' Curmudgeon]

we have a main seal leak.

Question is, is the crank named Nick? I shore hope not.:eek:

[dan200]

Yo Dan... look up at the very top of this website. Click on the Turn Key logo and give them a call! :D
Thanks Jerry.

Question is, is the crank named Nick? I shore hope not.:eek:
Now ya know I bet it is gonna be you who is gonna be over at lees replacing it. I was just tryin to find ya an little advice.:)

[Ol' Curmudgeon]

I'll bet a lot of folks figure I could use a crank seal, for instance, 30 revolutions of duct tape around my head!