clearance??

[rmracer09]

http://i681.photobucket.com/albums/vv175/rmracer9/GetAttachment.jpg

is there enough clearance to fit a 14 tooth sprocket??

[partybarge_pilot]

There should be.

[jbarker@banks]

sprocket: yes. the chain: doesn't look like it

[Mike @ pit b]

Why not just drop a few teeth on the back sprocket?

With a 14 in there you run the chance of having a rock get kicked up there and causing the chain to derail.

Just a thought.

[stuckthrottle]

self clearancing?

[partybarge_pilot]

self clearancing?

That's like a 16T......

[stuckthrottle]

it is. It's on an aprilia. I pulled the photo from the owners forum. Researching my next purchase ;)

[co pilot mclovin]

what bike is the sprocket going on?

[rmracer09]

what bike is the sprocket going on?

the bike is a cr250.

[cosmo]

Get Baja Bound Moto on here. He can tell you what kind of gearing a CR250 can pull!

[BajaboundMoto]

Plenty of room there for 1 more tooth.
We raced many many cr250's in Baja. The funniest was running 37 tooth rears and the chain would hit the hub at the sprocket bolt areas. We generally ran 39's.
I kinda doubt you're planning to go to that extent.

[rmracer09]

Plenty of room there for 1 more tooth.
We raced many many cr250's in Baja. The funniest was running 37 tooth rears and the chain would hit the hub at the sprocket bolt areas. We generally ran 39's.
I kinda doubt you're planning to go to that extent.

haha, but no 37t for me! just 14/48 most likely.

[FullsizeFun]

14/48 is a pretty good all around gearing I run 14/45 in the dezert on my CR250

[rmracer09]

14/48 is a pretty good all around gearing I run 14/45 in the dezert on my CR250

you have enough clearance for the 14t with chain and everything? is it a tight fit?

[FullsizeFun]

yep its in there and works fine