protools HPM 200???

[carczar_84]

Anybody have any experience with this bender? They have free plans on their website for building it. Any good or bad stories would be great.

http://www.pro-tools.com/200.htm

Also, i've been looking for plans for the JD2 model 3, or Protools 105 bender, does anybody have drawings for either of these?

Thanks again,
-Josh

[Triaged]

Read this thread
homebuilt tubing bender - Pirate4x4.Com Bulletin Board (http://www.pirate4x4.com/forum/showthread.php?t=376183)

[Baileigh Inc]

Anybody have any experience with this bender? They have free plans on their website for building it. Any good or bad stories would be great.

http://www.pro-tools.com/200.htm

Also, i've been looking for plans for the JD2 model 3, or Protools 105 bender, does anybody have drawings for either of these?

Thanks again,
-Josh

This is an inexpensive solution, and a great way for someone on a tight budget to get into a bender....although......

This bender is quite limited (90 degrees) and you will also sacrifice bend quality due to the lack of a fixed counter bend die. You will get flattening on the outside of the bend.

[atomicjoe23]

Do a search there is a thread on this forum with the blueprints for the JD2 bender.

If you can't find the thread send me a PM and I'll hook you up.