22r engine help????

[scott1450]

I am having a little difficult time getting my 22r to fire???

Finishing a 1450
Removed: Dash, ECU, all stock wiring....

Need????
I can not get it to fire I have a coil , a magnetic pickup dist. and toggle switch type dash.
I can't figure out(brain f*rt) how to wire it with the minimum amount of wires?????????????

Any help?????????

[SPONSOR]

Membership in the largest desert racing community has its advantages - Participate in Forum Discussions - Send and Receive Private Messages - Maintain Public Photo Albums - Access to Groups - User Profile in our Social Network - Increased Access to more Sub Forums - Reduced Online Advertisements Join our community today

[bob380sx]

22r or 22re? The r is easy with stock ignition module. Just needs a ground and 1 hot at the ignition. If it’s a re that a whole new can of worms and a pain. The factory loom is tied in with the dash and other crap. Best thing to do with a 22re is get a swap harness here
http://www.offroadsolutions.com/old/...r-e_perfmounts

Or I have a mega squirt off a 22re that was doing just fuel using a ignition and distributor off a 22r for sale. It’s pretty simple and comes with all the needed sensors. all of it for less than half of the swap harness

[Dirt Yota]

Usually wont fire if the distributor is off a tooth. Loosen distributor a little and turn it all the way each way while cranking. If tries to fire you need to pull it out and move to next tooth. That's just number one thing.need more info