Steering setup suggestions front wheel drive

[Kenshiro]

Need tips for my front wheel drive project,, Not used to offroad steering setups, so i need some help.

single seat, aprox 2200 lbs race ready, aprox 10" - 12" travel, using Toyota 4runner spindles with custom a-arms, spindles mounted with steering tab backwards,, Measurements on the outside of front tires is
massive 86" on my little Honda, i need it to be that wide to get some travel.

What steering system would you recomend.?

High rev Honda engine.

I got this as a suggestion,, HOWE


2.5 X 4.5 TRAVEL POWER RACK W/S
1 705 BIG INLINE CONTROL VALVE SPLINE 3/4-30
1 1010 RESERVOIR W/FILTER #8/#10
1 210 T/C 1450 PSI ALUM PUMP W/OUT PULLEY
1 315 5.375 T/C ALUM SERPENTINE PULLEY
1 1104 IN-LINE COOLER

Pics and tips on ideas are very welcome,,

Thanks in advance.

Linus,,

[SPONSOR]

Membership in the largest desert racing community has its advantages - Participate in Forum Discussions - Send and Receive Private Messages - Maintain Public Photo Albums - Access to Groups - User Profile in our Social Network - Increased Access to more Sub Forums - Reduced Online Advertisements Join our community today

[Kenshiro]

Sure hope somebody can give me some hints in the right direction.

Can i lean the rack forward, to get a better angle on the steering wheel input knuckle, short car, and my pedals will be very close to the rack.

Linus,,

[Ramsey_ElWardani]

Just use the stock steering, it won't be the thing to fail or leave you stuck or stransed.

[Dirtracer 619]

Howe performance is good so if you dont want to leave stock then you should direct this question directly to Howe to get the best answers

http://howeperformance.com/

[Kenshiro]

Talked to Howe, no problem to tillt the rack,, early stage in the build, don´t want to cut the frame tubing to soon, not sure how i will design the support/mount for steering rack. Just wanted to see if it would fit. 1/1 scale cardboard model, not fancy,,,,