Need info on what size to use on my front wheel drive offroad project
As i have a potentional sponsor here in Sweden it would be great to get as much info as possible.
I will not change the outer joints,, just inner
A-arm Upper ( thread and hole mesurements aswell as type/name )
A-arm Lower ( thread and hole mesurements aswell as type/name )
Steering Heims ( Howe 2.5 power rack, 4runner spindles ) ( thread and hole mesurements aswell as type/name )
The vehicle will be around 2500lbs
I plan to use square tubing for a-arms ( not same as mockup ) fabricated threaded suare bungs for heims.
Plated where extra strength is needed
Pictures of mockup A-arms on my facebookpage