Mason Motorsports 6100

[Robert Mason]

Here are a some pictures of the 6100 roller that we have just finished up!!

[SPONSOR]

Membership in the largest desert racing community has its advantages - Participate in Forum Discussions - Send and Receive Private Messages - Maintain Public Photo Albums - Access to Groups - User Profile in our Social Network - Increased Access to more Sub Forums - Reduced Online Advertisements Join our community today

[pdailey]

How was it fitting that Ford engine? Looks great! This class is going to be awesome.

[Neal Mason]

How was it fitting that Ford engine? Looks great! This class is going to be awesome.

Have not mounted the engine yet but based off of the dimensions it should fit fine in our trucks. The motor is very wide 29.5" and our engine compartment is 32.5" so its close but should not be a problem. Customer wants to remain anonymous. So if you know please don't spoil it

[pdailey]

Have not mounted the engine yet but based off of the dimensions it should fit fine in our trucks. The motor is very wide 29.5" and our engine compartment is 32.5" so its close but should not be a problem. Customer wants to remain anonymous. So if you know please don't spoil it

haha. 10-4! What do you think it will weigh at the start line?

[Neal Mason]

haha. 10-4! What do you think it will weigh at the start line?

I know what Steve Larozas weighed at the start line with the ecoboost and the AGM Jacking system with about 50 gallons of fuel in the tank it was 4444Lbs on the scales right before the race. This truck is the same except for motor and Jack system. You can lose 60 lbs just on tire selection

[Robert Mason]

[esbyota]

New body looks awesome! Looks like you have done alot of little changes to the entire chassis, keep up the good work!

[bigtex]

Man you guys just finished that 7200. You guys are knocking these things out! If you do not mind me asking when was this one ordered? Seems like you guys on are on a 10 week turn around? Aren't most builders on a 10 month turn around or longer?

[Neal Mason]

Man you guys just finished that 7200. You guys are knocking these things out! If you do not mind me asking when was this one ordered? Seems like you guys on are on a 10 week turn around? Aren't most builders on a 10 month turn around or longer?

First Tubes were laid on April 4th. There was other prep going on at the shop at the same time.

[dezrider]

Beautiful work as usual Neal and Robert. We were lucky to get the first 7200 from you and have always been thrilled with the truck. Now taking it to next level I can only imagine the anticipation of your "anonymous" buyer. Congratulations on this new class build and when can we expect the first MASON MOTORSPORTS trophy truck....