chevy hubs on ford 4x4 danna 44 knuckles

[izzi644]

i was wondering if anyone new what chevy hubs would bolt up to ford d44 knuckles? im doing a i beam conversion on my toyota pick up. i have a t100 rear end for it that has a 6x 5.5 lug pattern. i want to keep the same lug pattern on all 4 corners so that i dont have to carry 2 diff wheels as spares, so what i am trying to do is use ford beam ends and knuckles and use chevy hubs so that i can have the same lug pattern all around.

any help would be greatly appreciated. thanks.

[SPONSOR]

Membership in the largest desert racing community has its advantages - Participate in Forum Discussions - Send and Receive Private Messages - Maintain Public Photo Albums - Access to Groups - User Profile in our Social Network - Increased Access to more Sub Forums - Reduced Online Advertisements Join our community today

[TRichards]

I would think a hub from a K5 blazer 4x4 would work. I think they are 6 lug and the K5 straight axle is a Dana 44.

[Ramsey_ElWardani]

I would think a hub from a K5 blazer 4x4 would work. I think they are 6 lug and the K5 straight axle is a Dana 44.

they are not all Dana 44, be sure to find a D44 of a 1/2 ton or Blazer.

[izzi644]

thanks guys . i ran into another problem though, i guess there is a small bearing hub and a big bearing hub. would you guys happen to know which one it is that will fit?