I came across Beth some time ago. From the start I really liked her looks, her package, and her bolt-ons.. she had alot of things I was interested in and I knew we could make something work. We started to see eachother every day, I took her to work and back and out with my friends. We got more serious and began to go places for the weekends, holidays, etc. We went to glamis on New Years and Ocotillo a few times as well. Some great times were had and I began to see what Beth was about.
After some memorable moments and great times with eachother I came to realize something.... Beth had some serious, deep-rooted issues that were unfortunately not repairable. The only way to make things work involved starting over from the begining. I accepted this as a good thing. It gives me the chance to start over and build things from the ground up.
I am doing all the work on this myself. This will be one of my daily drivers and will NOT replace my explorer project if any of you know of that..
lets do the spec thing:
basics
-03 supercrew/ "no fear" addition w/all options
-every exterior engine mod available
-front clip
-projectors w/HID's
-full system
-momo wheel
-6 real beadlock gordons
..and whatever else I cant remember while typing this.
Membership in the largest desert racing community has its advantages
- Participate in Forum Discussions
- Send and Receive Private Messages
- Maintain Public Photo Albums
- Access to Groups
- User Profile in our Social Network
- Increased Access to more Sub Forums
- Reduced Online Advertisements
The truck is going to get rebuilt front and rear. The first thing I knew I needed to do was make it mobile. It will need to be able to roll outside, and if there is no suspension attached it needs some sort of cart. a cart that can support 6k lbs. or similar
the factory crossmember was previously "cut out" and the replacement was a single tube going across. (which looked like a banana when I cut it out.
The truck will still have a beam setup, so a crossmember is a absolute must. I wanted to design something that would have alot of weld area and pick-up points to the frame rails. Above all else, It cannot twist or bend etc.
Reply With Quote
