Beth.

[clarke1]

finished panel with allen head countersunk mounts and battery access panel


....only

[SPONSOR]

Membership in the largest desert racing community has its advantages - Participate in Forum Discussions - Send and Receive Private Messages - Maintain Public Photo Albums - Access to Groups - User Profile in our Social Network - Increased Access to more Sub Forums - Reduced Online Advertisements Join our community today

[clarke1]

....only>> 2 more sections of aluminum before I move to the front kingpin build

[clarke1]

well the aluminum has taken more of my time than I anticipated, but getting closer. bead rolled, small guage vertical panels will get built when Beth is sitting on all 4's and bottoned up.

First up:

Skid plate/rock guard area after the axle. Wanted to do a set in/clean plate with no visible fasteners. This also makes them easy to service/remove from only one side

[clarke1]

...front wall/hinge panel for the rear compartment.

*will be fully closed in, but not "sealed"

[clarke1]

bump stop and limit strap access/service panel

[clarke1]

hinged compartment cover with latches.

[clarke1]

I still need to make the lower compartment panels etc. it was my goal to at least have the top pieces done, and they are...

[clarke1]

and yes... Beth got TWO in her rear.. more pics when things are little more cleaned up

[ZTFab]

and yes... Beth got TWO in her rear..

Sounds like a good egg.

She got a sister?

Looking really good Morgan.

[clarke1]

Thanks ZT...

looks like there is going to be time tomarrow for some work to get done. We will see...

-Morgan