2" hollow snout set up for Wide 5 hub

[Bysch]

Does someone make a hub that will go on a snout made for wide 5 hubs that is 5 on 5.5? The bearing spacing on the wide 5 snout seems to be about an inch longer than what is on a blitzkrieg snout lets say??

[SPONSOR]

Membership in the largest desert racing community has its advantages - Participate in Forum Discussions - Send and Receive Private Messages - Maintain Public Photo Albums - Access to Groups - User Profile in our Social Network - Increased Access to more Sub Forums - Reduced Online Advertisements Join our community today

[Jerry Zaiden]

Get me the measurement and i will let you know. We have a 2" wide setup for front hubs.

www.camburg.com/products/hub-kits/

[Bysch]

I was just gonna wait until Friday to ask you but thank god you have something, I already started building the spindles when it was still a buggy and now that its a truck, I thought the spindles were useless. Overall bearing spread, outside to outside, measured on the snout is 3.125", don't know how wide the bearings are so can't tell you inside to inside, but im sure you get the picture, thanks.

[CaptinCrash]

Ryan plowman has that kind of setup on the front of his car I'd send him a pm.

[gawdodirt]

I was just gonna wait until Friday to ask you but thank god you have something, I already started building the spindles when it was still a buggy and now that its a truck, I thought the spindles were useless. Overall bearing spread, outside to outside, measured on the snout is 3.125", don't know how wide the bearings are so can't tell you inside to inside, but im sure you get the picture, thanks.

Check with Howe. Camburgs parts look similar to the Howe GN stuff. Very strong either way, but cheaper if you google for Grand National rather than off-road. Snouts were $35.00 from Howe. Hubs are $179.00 or so.

GD

[slvrbullet]

Does anyone make a 5 x 5.5 GN hub? It seems they are all 5 x 5 pattern or wide 5.

[racer56]

Does anyone make a 5 x 5.5 GN hub? It seems they are all 5 x 5 pattern or wide 5.

Mittler bros.

[Jerry Zaiden]

Does anyone make a 5 x 5.5 GN hub? It seems they are all 5 x 5 pattern or wide 5.

www.camburg.com/products/hub-kits/

We have a 2.250" bearing hub kit offered for front and rear. They are the same offsets as a GN hub but with stronger bearings and more bearing spread.

Also our hubs are made out of 7" O.D. material instead of 6.5" material so there will be NO cracking around the wheel studs with the Camburg hubs.