December 22nd, 2004, 19:32
Camburg's NEW I-beam Ranger Engine Cage .......
We’re proud to announce that our new weld-on engine cage is available for all ‘86-97 2wd Ford Rangers. We’ve gathered up all our knowledge and racing experience and put together a design that is levels above the competition.
Our engine cage is built using thick 1.5” x .188 wall DOM tubing not thinner .120 tubing for added strength and rigidity and has 3 mounting points per side, not just 2.
It’s designed to be used with aSAW 2.5” x 14” coilovers and cycle 19” – 20” or FOX/KING 2.5” x 12” coilovers and cycle 16” – 17” with our Camburg extended beams.
The shocks are mounted at the correct angle to give you more efficient dampening with a consistent and accurate motion ratio. Many shops do not mount coilovers correctly as it takes more time and skill to do it this way.
Our engine cage kit includes coilover mounts for each side and an engine brace that ties each mount together solid.
We also have available bolt-on mounts for 2.0” SAW/FOX/Bilstein airbumps.
It comes powder-coated gray with the welding areas still raw, includes all the grade 8 hardware you’ll need and is easy to install since we use constant points on the frame to locate it prior to final welding.
The engine cage sells for $799 or $1099 with the airbump mounts and is available through your local Camburg dealers/distributors.
This is only one of many new products we’ll be releasing in the near future.
- Scott @ Camburg Engineering
December 22nd, 2004 19:32
Membership in the largest desert racing community has its advantages
- Participate in Forum Discussions
- Send and Receive Private Messages
- Maintain Public Photo Albums
- Access to Groups
- User Profile in our Social Network
- Increased Access to more Sub Forums
- Reduced Online Advertisements
Join our community today