What brand bumps are these?

[sirhk100]

I've got one that needs rebuilt. They look like hell but work fine. 3 of the 4 I've got hold pressure WAY longer then my Bilsteins ever did!!! The closest looking bumps I've found to them are Yarnell bumps but they generally have a mounting sleeve on top or at least all the ones I've seen do... Notice there's no groove for a snap ring...

Any idea?
Thanks,
Khris

http://www.dezertrangers.com/iB_html...4-DSCF0382.JPG

http://www.dezertrangers.com/iB_html...1-DSCF0383.JPG

http://www.dezertrangers.com/iB_html...6-DSCF0384.JPG

[SPONSOR]

Membership in the largest desert racing community has its advantages - Participate in Forum Discussions - Send and Receive Private Messages - Maintain Public Photo Albums - Access to Groups - User Profile in our Social Network - Increased Access to more Sub Forums - Reduced Online Advertisements Join our community today

[Ryan_P]

My guess would be Yarnell. Hope that helps.

-Ryan

[91yotaprerunner]

hey guys, i recently acquired these bumpstops to use for the shootout since khris is such a nice fellow, does anyone on here have any experience with these things, anything i need to know before using them? good or bad things about them? any info will be appreciated

thanx

matthew

[ntsqd]

They look like Shaw's to me. Might call him and ask if they are.

[sirhk100]

Your welcome... LOL, definately shaws... Go buy the snap rings from a set of Bilsteins and machine a groove for them. Don't go too deep though!!!

[Bryan_D]

You could call Lee at Race shock in Phx and he might be able to help you.

Nevermind I though you were in Phx or Prescott with Khris.

[91yotaprerunner]

na, havent been in arizona with khris since parker, lol. i was mainly just looking to see if anyone on here has ever used these and had any experiences with them and could give me some opinions.

[SLR]

What the hell is the problem??? Air over oil and run them @ 250 PSI. If the rear is bucking slow down and run them @ 65-100. Don't know how low you can run them RIGS. Marvin is a totally cool guy and his # is in the back of the Dusty Times. LET MARVIN SHOCK U.... 91 COAL MINNER....

You can run any snap ring, Just do yout homework on the can. Just make sure to have your snap ring stop on your mounting can and a pinch bolt\can support on the top. (Because I know yout truck is going to be BUCK'IN) and its going to push that snap ring and work that bump and mount...

FYI, The new bumps have a 1/2" ID bolt on top with a different end cap design.



You going to unleash all 20 in front?!?

[91yotaprerunner]

ya ive seen how the new ones have the bolt sleeve on the top....

i will not be running all 20 inches up front, ill be bumping and strapping it down to 17-18. Gonna get rid of the bumpsteer at full droop/bump.

and Spencer, im ditching the fox's, picking up a set of 2.5 X 16 kings this weekend for the rear end, so that should help a little bit. Ill be in cali this weekend, ill see if i can swing by the shop and check stuff out.