Here is a new truck being built by Ross Savage using our Camburg Suspension parts.
 |
||||||||
|
|
||||||||
|
Here is a new truck being built by Ross Savage using our Camburg Suspension parts.
Membership in the largest desert racing community has its advantages
- Participate in Forum Discussions
- Send and Receive Private Messages
- Maintain Public Photo Albums
- Access to Groups
- User Profile in our Social Network
- Increased Access to more Sub Forums
- Reduced Online Advertisements
Join our community today
Very nice Jerry
Jerry,
This truck's front suspension is using your new I-beams correct?
Wasn't sure from the angle of the photos.
Looking good Jerry. And without superfluous bling.
Support Our Troops ------ If you can't stand behind them, feel free to walk in front of them.If your looking for something blingy and complex, I'm delighted to disappoint you!"[Nye Frank] built the best, and never looked to anyone for recognition, the mark of a true man, one of the last true cowboys of our sport!""The greatest obstacle to discovery is not ignorance -- it is the illusion of knowledge"If you are racing a fair race...your strategy sucks!
looks great, did you guys get the bare housing from DT then weld on your link mounts?
the quality is top notch as always.
Jason
Thank you guys!
Yes the beams are our new Equal Length beam set up with custom spindles and billet hubs. I will take more pictures when he gets the steering installed.
The rear end housing is from Dirt Tech. They make us a mig welded housing and we tab it for our 3 link and set up the brake mounst and snouts. The hubs are our new design for prerunner trucks with a 2.25" bearing and a wide spread. The axles are 35 spline and we use Wilwood brake parts. I will also get more pictures of the rear end in a few weeks.
This truck will be fun to watch! It should have at least 300 RWHP (way more than my 170and be running in BITD but might show up to a few local races to test it out.
Nice!
Nikita Khrushchev said"We can't expect the American People to jump from Capitalism to Communism, but we can assist their elected leaders in giving them small doses of Socialism, until they awaken one day to find that they have Communism. "
Here is a better picture of what is going on with the spindle and beam combo... no more king pinsOriginally Posted by DSRacing
Complete with our hubs
Very nice. Can you tell us what that setup would cost.
Nice work Jerry.
Posting Permissions
Reply With Quote
