October 11th, 2007, 20:35
hey i have done some research on a small welder, i dont do any thing heavy duty but iam between the Millermatic 180 or the Lincoln 180c....any ideas? Pros Cons? They are relatively the same price
October 11th, 2007 20:35
Membership in the largest desert racing community has its advantages
- Participate in Forum Discussions
- Send and Receive Private Messages
- Maintain Public Photo Albums
- Access to Groups
- User Profile in our Social Network
- Increased Access to more Sub Forums
- Reduced Online Advertisements
Join our community today
October 11th, 2007, 20:40
both are great welders and you can't go wrong with either one. I have a miller 210 and has done every thing I have asked of it.
October 11th, 2007, 21:11
Pick a color. Red or blue.
I have a Miller 210 and 350p. I use the 210 for thinner things (.188 and down but it works great for .25 too). The good thing about the larger machines is that larger rolls of wire cost less. Price out a 10lbs roll vs. a 30 lbs roll of 70s6.
Of course this only matters if you weld alot.
Braking anvils with rubber mallets
October 14th, 2007, 19:16
look at the feature on the miller 350p vs the lincoln 350 mp then price. Lincoln has em beat hands down this year. It does tend to flip flop every couple of years as each is always trying to out do the other. Both are quality units, versatility was the determining factor for me.