mig welding settings

[westtexasbaja]

Do fabricators adjust mig welder settings based on the pattern they're using (straight-line vs circles/figure 8's)?

I've gotten to where I use straight-line for smaller stuff, but do I need to reduce wire speed & amps when using a circle pattern to keep from getting too hot? This would be for the same material thickness (like weld-washer vs cage joint).

Thanks,
G.

[SPONSOR]

Membership in the largest desert racing community has its advantages - Participate in Forum Discussions - Send and Receive Private Messages - Maintain Public Photo Albums - Access to Groups - User Profile in our Social Network - Increased Access to more Sub Forums - Reduced Online Advertisements Join our community today

[Chase 2]

Might I recommend you try asking the same question here:

www.offroadfabnet.com

[westtexasbaja]

Thanks for the link.