Reinforcement washers in SD area?

[Sites]

Hey guys,

Can anyone recommend a shop that might stock weld-in reinforcement washers in the San Diego area? I have one set from Kartek (link below), but I need one more 1/2" set hopefully tomorrow.

http://www.kartek.com/products/all/fab/fab.htm

Thanks,
Andy

[SPONSOR]

Membership in the largest desert racing community has its advantages - Participate in Forum Discussions - Send and Receive Private Messages - Maintain Public Photo Albums - Access to Groups - User Profile in our Social Network - Increased Access to more Sub Forums - Reduced Online Advertisements Join our community today

[[email protected]]

maybe ORW?

[Jerry Zaiden]

Andy,

You can buy the original Camburg weld washers from Race Ready.

[punchdrunk monkey]

I think Fiber-Tech in Santee sells them.

[Sites]

Thanks for the replys. I actually just ended up making my own set this morning.

[Justin]

Andy,

You can buy the original Camburg weld washers from Race Ready.

Because nobody made them before camburg.

[Offroad-Engineering]

Found this alittle late but we have the in stock, for future reference. 19.99 for set of four. Located in Lakeside, 858-231-6449 (Bryan)

[Jerry Zaiden]

Because nobody made them before camburg.

We have been supplying the industry these for around 11 years now.... You can buy them at McKenzies, Race Ready, Butch's Speed shop, etc....

[fftront]

what are these used for?

[Jerry Zaiden]

These are used to reinforce bolt hole areas. The Camburg design in a .250 thick 4130 washer with a .125 flat before the step up taper this helps with the welding. We have these for 7/16", 1/2", 9/16", 5/8", and 3/4". They are $15 for 4 of them.