help!chevy 4.3 v-6 with painless wiring harness.

[goofballracer]

im in over my head with my baja bug i put a 4.3 v-3 chevy motor tbi and a painless wiring harness......its not so painless. i need help with the ignition wires and wires from the starter all wires are labeled but im new at this and i dont know what is supposed to connect to what. help please is there anyone local to san marcos vista that would take some small pay cuz i dont have alot of money to help me out. or any advice is much appreciated.

thank you ahead of time

[SPONSOR]

Membership in the largest desert racing community has its advantages - Participate in Forum Discussions - Send and Receive Private Messages - Maintain Public Photo Albums - Access to Groups - User Profile in our Social Network - Increased Access to more Sub Forums - Reduced Online Advertisements Join our community today

[dezertdude]

have you called painless? they should be willing to help you out.

if all else fails, take pics of the wiring harness and corresponding parts and someone should be able to tell you what to put where.

[goofballracer]

ok i would have called them but i was emailing a guy from there kind of a dick but ill try calling

[Ryno]

If you need a scanner to tune it, let me know, I have one in Poway. I'll be down this weekend, let me know.

[Steve0]

I would come down to help you out, but I'm not free unitl next week. It would cost you about 30 in fuel and the beer i drunk while I was there.

[goofballracer]

im down with that

[stevenc]

Goofballracer,

How much do you have left to do? Just the ignition wiring and starter?

[Ryno]

I pulled a TBI motor this weekend, I think I know what you're talking about. You need to find the year of the motor, then get the accessory for that year, or cut off the weatherpack plug. Everything is weatherpack on the TBI stuff. The ignition is dual plug, with wires from the starter, and going to the dist. 2 plugs on back of dist. as well. If you need help, let me know.

[85yota]

on my paintless the Crank signal wire goes to the same pole that the wire from the ignition switch to starter solenoid went to, lets the comp know it's cranking and gives it more fuel, then hook up the hots and ground for the ECM relay and everything. I'd just call them i'm sure there's people that have been more confused then you.