J-C Engineering Silverado Build

[Offset Photography]

Josh over at J-C Eng. has been rebuilding my buddy Jeff's Silverado... Its been a slow rebuild as money permits, but since Jeff isnt on RDC, I figured I'd share here.

Here is what the truck used to look like:









And now the complete Rebuild...

-swapping the 4.6L V6 for the 5.3L V8
-Backhalf and link
-BMS Rear End
-re-designed J-C engineering front suspension
-J-C Links
-J-C Front Hubs

The pictures:








J-C engineering custom hub, arms and spindle ,should be pulling about 20" of travel




The blitz rear end


motor mounts


tranny mount

[SPONSOR]

Membership in the largest desert racing community has its advantages - Participate in Forum Discussions - Send and Receive Private Messages - Maintain Public Photo Albums - Access to Groups - User Profile in our Social Network - Increased Access to more Sub Forums - Reduced Online Advertisements Join our community today

[Offset Photography]

[Offset Photography]

the bottom inside rail

[Offset Photography]

[Offset Photography]

The truck was being built at Jeff's fiances house but now the truck got a new home at joshs shop in orange county so it hopefully will be a lot easier to work on the truck and get it done maybe a little sooner.
heres a pic of the rear end

[Offset Photography]

got the shock mounts welded on the truck and then got the upper link mount all welded in

[Offset Photography]

[Rhinestone Cowboy]

Looks good man. Keep it up

[Offset Photography]

I'll update this as I get more pictures from Jeff or Josh, or I will try and go down there this week and update you guys. It should be finished hopefully just before summer. Jeff has been traveling to New York for work so work slowed a bit more.

[RoosterBooster]

great pics

hmmm... that trailing arm is sweet...i guess no shock eye extensions needed with that design ?!?