Extended Half Shafts/2 piece shafts...
I have been researching half shafts/CV's for months now. I have yet to come across anyone who has extended the stock shaft of a CV jointed half shaft. Is it even possible? Does the shaft have to be solid or can it be a 2 piece shaft, with some kind of joint in the middle? These are just a couple of the questions I can't seem to find definitive answers too.
I have found a CV joint made by Dephi that uses a type of coil as the shaft but I'm sure those are extremely expensive.
Would it be cheaper to just have complete custom CV jointed half shafts made?
This is for a project that is still a while out but material on this topic is somewhat limited and repetitive. The vehicle this is for is an '01 Ranger 4x4.
May 21st, 2003 13:50
Membership in the largest desert racing community has its advantages
- Participate in Forum Discussions
- Send and Receive Private Messages
- Maintain Public Photo Albums
- Access to Groups
- User Profile in our Social Network
- Increased Access to more Sub Forums
- Reduced Online Advertisements
Join our community today