How close could I safely mount the pan of a T400 away from the bottom skid plate?..This is a front engine truggy layout...Thanks!
 | ||||||||
|
| ||||||||
|
How close could I safely mount the pan of a T400 away from the bottom skid plate?..This is a front engine truggy layout...Thanks!
"Imagination is more important than knowledge"
-Einstein-
Membership in the largest desert racing community has its advantages
- Participate in Forum Discussions
- Send and Receive Private Messages
- Maintain Public Photo Albums
- Access to Groups
- User Profile in our Social Network
- Increased Access to more Sub Forums
- Reduced Online Advertisements
Join our community today
How thick of skid plate? I run a 1/4" thick aluminum plate with 1/8" of clearance. Any thinner plate, I would use 1/4" minimum clearance.
sharp tools throw big chips
I was planning on using 1/4"....Thanks!
"Imagination is more important than knowledge"
-Einstein-
try to find a hard alloy like a 7000 series aluminum. The lower # alloys are softer and more prone to bending.
sharp tools throw big chips
Posting Permissions
Reply With Quote
Bookmarks