front spring hanger problem

**singlehanded** · October 14th, 2003 15:15

What would you guys recomend doing, the back hole seems to have worn a little on the bottom?

I'll post some mote pictures of my project so far........

**SPONSOR** · October 14th, 2003 15:15

Membership in the largest desert racing community has its advantages

- Participate in Forum Discussions
- Send and Receive Private Messages
- Maintain Public Photo Albums
- Access to Groups
- User Profile in our Social Network
- Increased Access to more Sub Forums
- Reduced Online Advertisements

Join our community today

**singlehanded** · October 14th, 2003 15:17

1

**singlehanded** · October 14th, 2003 15:18

2- body mounts

**singlehanded** · October 14th, 2003 15:20

3- interior

**singlehanded** · October 14th, 2003 15:21

4- interior two

**singlehanded** · October 14th, 2003 15:22

in front of firewall

**singlehanded** · October 14th, 2003 15:23

6- in front two

**In_the_works** · October 14th, 2003 15:29

Add some weld where it ovaled, then drill it back to original size, then put a weld on washer on the outside of the hanger with a hole the exact size of the spring bolt. Should be stronger than it was to begin with.

**singlehanded** · October 14th, 2003 15:31

this is just the quality of work that some big shop have. Looks like Im going to weld the rest up myself. funny I dont remember any discount for the 3/4 done welds.....

**singlehanded** · October 14th, 2003 15:51

That might be good. I was thinking about sanding the sides flat and welding on a 4130 washer from camburg?? I will aslo be adding a tube from the top of the hanger to the frame..