Camburg built KINETIK 7200/6 truck for TSA Motorsports

[CRAIG_HALL]

Separation lines are waterjetted. these were prototypes of sorts to try out. I'm guessing Camburg might have them available raw as well as anodized? I make them but they're available thru Camburg.

[SPONSOR]

Membership in the largest desert racing community has its advantages - Participate in Forum Discussions - Send and Receive Private Messages - Maintain Public Photo Albums - Access to Groups - User Profile in our Social Network - Increased Access to more Sub Forums - Reduced Online Advertisements Join our community today

[Jerry Zaiden]

Jerry, do you sell the 1.75/1.50 separation clamps for the water lines? If so, are they machined or simply cut?

Send me your number and i will call you about the clamps if you are wanting to buy them. [email protected]

[Jerry Zaiden]

Here are a few pictures of these clamps.

[Combz08]

sexy!! when will Burg be offering these?

[SPROCKET]

Awesome build! Are you not worried about the location of the Wix filter? (maybe its the picture just looks a little close if the drive shaft failed)

[Jerry Zaiden]

They are available but the final product will be anodized.

[Jerry Zaiden]

Pyrotect fuel cell just showed up. Waaaayyyy nicer than fuelsafe and harmon. also FIA approved.

[Scott_F]

All us poor folks are wondering how much a fuel cell like that costs.

[CRAIG_HALL]

I squeezed every bit of room out of the chassis to draw this up. We have a simpler cell for a LS3 powered truck with much better fuel economy.

[Jerry Zaiden]

All us poor folks are wondering how much a fuel cell like that costs.

Retail is $6500