1. Forum membership has its advantages....

930 cv have a direction ?

Discussion in 'Shop - Driveline' started by eilatmar, Apr 3, 2009.

  1. eilatmar

    eilatmar New Member

    Joined:
    Nov 9, 2006
    Location:
    eilat israel
    hi frinds
    iam going to use 930 cv`s on my buggy but not sure if its have a side that go into the flang and a side that gos to the axle.
    thanks
    hanan
     
  2. punchdrunk monkey

    punchdrunk monkey Active Member

    Joined:
    Apr 5, 2006
    Location:
    Poway, CA
    Here's a good picture for you.

    [​IMG]
     
  3. punchdrunk monkey

    punchdrunk monkey Active Member

    Joined:
    Apr 5, 2006
    Location:
    Poway, CA
    [​IMG]

    [​IMG]

    [​IMG]

    [​IMG]
     
    (+1) 1 person likes this.
  4. Tipracer

    Tipracer Well-Known Member

    Joined:
    Sep 6, 2005
    Location:
    So. CA
    while it is not as important to use the cv's in the same position as they came out as in direction of rotation, it is very important that the axels be used in the same direction of rotation ...you can use the left side on the right side ONLY if you swap the inside end of the axel to the outside end when going from right side to left side
     
  5. Ramsey_ElWardani

    Ramsey_ElWardani Ironman

    Joined:
    Apr 1, 2001
    Location:
    Carlsbad, CA
    Great posts and pictures. I have been using the same methods for years with perect redults. Though I position the cage as you do, it is interesting to note that Fortin suggests the opposite; small dia. inside. I've found it does not seem to matter. This was from an old thread:
     
  6. 07FJRog

    07FJRog Well-Known Member

    Joined:
    Feb 26, 2009
    Location:
    Tonopah, AZ
    great pics for assembly, thanks

    +rep

    Rog
     
  7. Kbach66

    Kbach66 Member

    Joined:
    May 9, 2002
    Location:
    Simi Valley, CA
  8. eilatmar

    eilatmar New Member

    Joined:
    Nov 9, 2006
    Location:
    eilat israel
    dear frinds
    thank you very very much.

    this is my project.
    hanan

    [​IMG]
     

Share This Page