Bent Torsion Housing!


Well-Known Member
On my Pre-Runner buggy/Tandem Car, the torsion housing is slightly bent. This slight bend is causing approximately 2inches of rear wheel toe out. So I know I have to somehow bend the center of the torsion housing back towards the rear of the car. I am not quite sure how to do this. ANY IDEAS????

pLEASe HELP!! :eek::eek::eek:


Baja Fool

Well-Known Member
Take it to alignment shop that straightens frames and such. I'm in the South Bay and there is place Irvine's Alignments in Harbor City; these guys correct frames on all types from Buses to bugs.

Of course by bending it back you have compromised the strength of the housing to some extent....

Good luck.