Buggy Rear Trailing Arm Pivot Setup

[Scott24]

I am setting up a new dualsport buggy with a aftermarket torsion housing. I bought the setup jigs but they are not the same side to side. The left side is at 6-7 degrees down in the back. The right side is at 0 degrees. they are just tacked in lightly. I am sure they should be at the same angle. What angle should they be at. I will be running about 16"+ travel front and rear. The car is on stands and leval front to rear.

 

[Scott_F]

6-7* sounds ok. The inner pivot should be rearward of the outer pivot at your chosen angle.

 

[Scott24]

Thanks for the input. Any one else have any suggestions?