Reply to thread

Message: <blockquote data-quote="Ryno" data-source="post: 13766" data-attributes="member: 228">If you can draw it, a welding shop can make it.  I know that Poway Welding can do it, I use to go to them for all kinds of stuff.  Just give them dimensions, and a ballpark on the angles for the bends.  You can buy an angle finder that a carpenter would use @ Home Depot for about $3.  From there, transfer the angle, and then find it with a protractor, or a framing square.  Can you tell I'm a carpenter?  =)  Poway welding will also make it fit to whatever size you want, or do a rough piece, either way.  They are the only reasonable shop I know of in North County.  I would guess they would charge about $200 for a finished dash, with no holes except the cutout for the column.  RynoBuild it like a Rhino, and Leave it be.</blockquote>