dana 35 with 44 knucles

murphco

Well-Known Member
Joined
Jan 22, 2003
Posts
436
Reaction
3
Location
AZ
does anybody have any info on putting 44 knuckles on a 35.after looking at a bare 35 housing and a 44 knuckle and they looked compatable aside from the lower ball joint stud size.

aligned by laser,adjusted by hammer.
 

hoeker

Well-Known Member
Joined
Oct 9, 2002
Posts
2,004
Reaction
101
Location
holland, MI
Website
www.rosshoek.com
don't know what your doing, but your best off dumping the 35. if you off road at all, they don't hold up for long.

do know the swap is possible, thought spindles out worked.

<A target="_blank" HREF=http://www.rosshoek.com>www.rosshoek.com</A>

Some are born great, some achieve greatness,
and some have greatness thrust upon them.
 

jarreptolson

Well-Known Member
Joined
May 15, 2001
Posts
152
Reaction
0
http://www.therangerstation.com/35with44parts.html an article on dana 44 parts on dana 35's

I would have to disagree and say that the dana 35 has held up very well in my truck. The only weakness i have found is the housing itself, getting it plated fixes the weakness i think john at autofab charges like 200 or 250 for the plating and it is well worth it. This is all depending on your application, i can hit high desert speeds and occasionally you'll find me rockcrawling with my jeep buddies. and i always get a laugh pulling people out of the deep sand.
 

murphco

Well-Known Member
Joined
Jan 22, 2003
Posts
436
Reaction
3
Location
AZ
the 35 it will go on is plenty stong,it,s gusseted,boxed and widened with1" rod ends at the pivots.i was looking for someone that had possibly done it at had results.i'll check the ranger website,thanks.

aligned by laser,adjusted by hammer.
 
Top