Drilling out Method 105 bead locks to 5/8

slvrbullet

Well-Known Member
Has anyone successfully drilled out Method 105 bead locks from 14mm to 5/8? I was planning on using a ridge reamer and drill for this but am also worried that their is enough meat to drill them out?

Anyone know of anyone who carries m14 wheel studs with a .685 knurl?
 

biggjim

Well-Known Member
Has anyone successfully drilled out Method 105 bead locks from 14mm to 5/8? I was planning on using a ridge reamer and drill for this but am also worried that their is enough meat to drill them out?

Anyone know of anyone who carries m14 wheel studs with a .685 knurl?
I just removed some 14mm's from a brand new set of hub's I will check them to see what the knurled diameter is.
 
Top