Extreme balljoint angle HELP!

[JCosby]

What would cause the upper ball joint to be at that much of an angle, it's the same on both sides.

 

[orbot]

lifted the truck lately?

 

[JCosby]

lifted the truck lately?

It's got 3" Fabtech spindles, fox shox. The upper ball joint came out of the socket and I replaced both ball joints, the angle just doesn't look right, honestly I'm scared to drive the thing.

 

[Ramsey_ElWardani]

I would be too.

Get rid of the Fabcrap or get some aftermarket UCA.

 

[JCosby]

Yea I've been looking at getting UCA's, just can't decide what to get

 

[SoCalSuperTrucks]

The angle doesn't look horrible but if a cheap Kragen or O'Reilly balljoint was used we wouldn't be surprised if you had the issue. Is the camber negative (top of tire lean in)?

 

[biggjim]

Your not going to get a press in balljoint to stay....that deal looks like there is 0 droop travel and it's maxed out. Bring your preload down a little