• Forum membership has its advantages....

harness for a 4.0 ohv

heman

Well-Known Member
WOULD ANYBODY BE ABLE TO HELP ME OUT,I AM TRYING TO FIGURE OUT WHAT WIRES TO ELIMINATE FROM MY HARNESS AND DELETE ALL THE BS NOT NEEDED TO START MY 94 FORD 4.0 OHV ENGINE. MAYBE SOMEBODY OUT THERE ALREADY SELLS THESE HARNESSES. MAYBE SOMEONE CAN POINT ME IN THE RIGHT DIRECTION. THX IN ADVANCE
 

Mitch_13

Member
I know this is an old thread but I am looking for the exact same information. Any help would be appreciated.
 

green787

Well-Known Member
Copper is expensive... There are no BS wires in your harness... Each wire serves a function... Why would the manufacturer put unecesary wires in the harnes????
 

dzrt performance

Well-Known Member
did you ever hear anything abou tthis? i would like the same info
I just built a harness from scratch for a 4.0. granted this is for a Motec system and not an OE Ford computer so if you are looking for information on the engine sensors and wiring i may be able to help. PM me if you need assistance.
 
Top