hummer portal question

D.Mavis

Well-Known Member
Posts
261
Reaction
4
Does anyone make an input shaft for a hummer portal that would accept a 934 cv instead of the stock hummer cv? I bet some of the hummer racers out there have upgraded axle shafts and cv's. it would be a pretty easy part to make but if someone had it on the shelf or was ready to make them I'd rather buy them than build them.

Thanks,

Damien
 

partybarge_pilot

Well-Known Member
Posts
6,541
Reaction
1,366
You need to ask Rob Everhart on here, he races a hummer and has done a lot of research on the CV's. His screen name is REVERHART.
 

HardCharger81

Well-Known Member
Posts
693
Reaction
27
There's a guy that races in VORRA that has a AWD buggy that uses hummer portal and Ford 9" center sections with custom axles.
I'm not sure the guys name, but that'd be a start.
 

partybarge_pilot

Well-Known Member
Posts
6,541
Reaction
1,366
There's a guy that races in VORRA that has a AWD buggy that uses hummer portal and Ford 9" center sections with custom axles.
I'm not sure the guys name, but that'd be a start.
That would be Brad Fallon. They are jag center sections, not 9".
 

scary fast hummer

Well-Known Member
Posts
3,362
Reaction
1,337
That would be Brad Fallon. They are jag center sections, not 9".

They are humvee center sections which are Dana 20 cases with AMC Eagle brakes attached. Jag units would have wrong gears for the portal style hubs.
 

reverhart

Well-Known Member
Posts
315
Reaction
4
here are the adapters we made for the portals to run 934 joints
 

Attachments

Top