mounting seats in a buggy

1992f150

Well-Known Member
Joined
Dec 23, 2001
Posts
373
RDC Crypto
0
Location
Azusa, Shame of the foothills
Website
www.y2khai.com
Im trying to think up a good way to mount seats in my tube frame buggy. I know I need a bar behind the back of the seat; I'm wondering about the lower mounts. The seat has 4 prongs that would bolt to a seat track, so I was thinking running 2 tubes per seat that fit just inside the prongs, then making some tabs off the tube so it can bolt to the seat prongs.
Any thoughts, sugestions, or pictures would be helpful.
Thanks!

Azusa: shame of the foothills
 

Kritter

Krittro Campbell
Joined
Jun 18, 2001
Posts
10,914
RDC Crypto
299
Location
Chino, CA
You could do the tubing or just do angle iron and drill holes in it and mount it to the seat tabs and then weld in teh angle iron...very easy and cheap to do

Kris
<A target="_blank" HREF=http://www.barneysprecision.com/fabproducts.htm> Fab Parts</A>
 

dirtydezracer

Member
Joined
Feb 26, 2003
Posts
21
RDC Crypto
0
Location
Orange County, CA
Angle iron is definately low buget and easy. In my truck I used square 1" tubing and shock tabs, that was simple too. --Paul

Drive vigorously, break, repair, repeat.
 
Top