Multiple shocks

crafty

Well-Known Member
When running multiple (Two shocks per corner) smooth body shocks is the psi set the same in all? The rear end is bucking hard. I was told to start with 180 psi. Should I offset pressure, say 180 in one and 160 in other? Will a lower psi help with the bucking?
 

partybarge_pilot

Well-Known Member
Using pressure to adjust for valving is a poor bandaid. If your running a lot of comp valving your are going to need a lot of pressure to prevent cavitation.
 

jon coleman

Well-Known Member
valve by temp, i had some bilstiens, one was hot, other luke warm, ( & too stiff ), soooo, i ditched hot one & put same cooler pn one on , better( lighter overall valving& temps really simular after run.
 
Top