Pre runner glass on a 1st gen 4runner

B

BlueCoyote

Well-Known Member
Posts
747
Reaction
140
Any one ever install fiberglass bed sides on a 1st generation 4runner? Realize they will be a bond on over the existing quarters. Did it fit around the tail light area okay?


Who are you calling Coyote ugly?
 
BIG_FAT_LOSER

BIG_FAT_LOSER

Well-Known Member
Posts
1,533
Reaction
3
Do they have to be bonded to the body of can the be Dzused on like the ones Perry's offers for the explorers <A target="_blank" HREF=http://www.perrysfabnfiber.com/>http://www.perrysfabnfiber.com/</A>

Duct tape is like the Force.It has a light side and a dark side,and it holds the universe together.
 
B

BlueCoyote

Well-Known Member
Posts
747
Reaction
140
could be dzused, but they might walk off. I was going to urethane glue / screw the sides on. This will be on my 86 'daily driver pre-runner' Only reason I was thinking of using bed sides is the 4runner has a crushed RH quarter (bought it as a salvaged roll over). Bed sides are less expensive and faster than installing a new quarter. Plus they look better.

Who are you calling Coyote ugly?
 
DougM

DougM

Well-Known Member
Posts
746
Reaction
9
talk to Camburg- they use a special aircraft bonding glue- read about it a frew years back when OFF ROAD magazine built a Chevy 1500 prerunner and Camburg helped- Im sure Jerry knows?!
 
Top