• Forum membership has its advantages....

Reverse intake manifold on LS

outlaws4x4

Well-Known Member
Hi i am looking to run a reverse intake manifold on my ls2 what problems should i expect? what is the solution to the valley plate and oil pressure sender?

thanks
Ash
 

07FJRog

Well-Known Member
I think you only have to plug the oil pressure sensor hole
 

Slippery P

Well-Known Member
Depending on the style of intake you will have to change the valley cover bolts to a button head.
 

Sean At CBM

Active Member
We always just chop the little stand off where the oil psi sender goes. Then weld it closed. Nothing else needs to be modified. Just make sure you don't switch your vacuum line around. If you need another spot to put your oil psi sending unit, right above the oil filter is where I would go.
 
Top