Reply to thread

Message: <blockquote data-quote="atomicjoe23" data-source="post: 1831445" data-attributes="member: 14072">So there are basically 3 choices when it comes to constructing the portion of the roll cage forward of the main hoop:  1)  a halo 2)  down tubes going from the main hoop along the roof and down the A-pillar with a header bar3)  a forward hoop that follows the A-pillars and windshield with bars going between it and the main hoop.Is there a distinct advantage of one over the other from a safety/protection or fabrication point of view?The only thing I can see is that the 3rd option would most likely require 4 bends in a single tube vs. 4 and two of those bends would be out of plane adding to the complexity of the part.Thoughts???</blockquote>