Shock valving

[jrs914]

Looking for some advice on valving fox 2.0 fronts w/res and fox 2.5 rears w/res. My car is a single seat cab forward and weighs in around 1750 lbs ready to race. My beam is turned 1/4 inch top and bottom with stock torsion leafs. I think the rear has 28mm 300m torsion bars.

Thanks

 

[BUDMAN975]

Cut out about 200LBS lighten up the torsion bars and get a Silcock front end, after that its all about spending time in the car and watching it work through the travel. for a single seater that is very heavy and even though the bar is too big so you would have to add so much rebound to make up for it and then you would have a problem with the rear suspension packing.