Wheel Studs

[gpbullock]

So I picked up a set of BMS hubs with 5/8" wheel studs, but the old hubs had 1/2 ". Is it recommended to drill them out to make them fit or will I need to buy a wheel that is set up already for the larger studs?

 

[partybarge_pilot]

Drilling your current rims is perfectly acceptable. If your using taper nuts, make sure you up the countersink also.

 

[Wahl_7s]

Drilling your current rims is perfectly acceptable. If your using taper nuts, make sure you up the countersink also.

X2 no problems, same on our race truck!